The following schematic shows a simple DEW sensor circuit diagram using LM258N IC. As the humidity around the circuit goes up, the resistance in the DEW sensor increases. When the resistance reaches a pre-specified level, the circuitry displays a warning message, and shuts down the external device
Under normal conditions, resistance of the dew sensor is low (1 kilo-ohm or so) and thus the voltage at its non-inverting terminal (pin 3) is low compared to that at its inverting input (pin 2) terminal. The corresponding output of the comparator (at pin 1) is accordingly low and thus nothing happens in the circuit. When humidity exceeds 80 per cent, the sensor resistance increases rapidly. As a result, the non-inverting pin becomes more positive than the inverting pin. This pushes up the output of IC1 to a high level. As a consequence, the LED inside the opto-coupler is energised. At the same time LED1 provides a visual indication. The opto-coupler can be suitably interfaced to any electronic device for switching purpose. Circuit comprising diode D2, resistors R5 and R6 and capacitor C1 forms a low-voltage, low-current power supply unit. This simple arrangement obviates the requirement for a bulky and expensive step-down transformer.
4N35 PC16552DV LM393M IR2110S LM386N-1 DS26C31TM UC3854DW
OPA2134ua OPA627AU MAX232ACSE MAX485CSA BAT54C
EPM240T100C5N PCF8574AT PCM1725U LM311N MAX1711EEG L2800-38
L6219 DG444DY
No comments:
Post a Comment